USING THE CRUISE CONTROL SYSTEM
ACCEL/RES switch (acceleration/return to previously set speed)
COAST/SET switch (course/stabilized speed setting)
CANCEL switch
System ON/OFF switch
The cruise control system provides automatic stabilization of vehicle speed without the driver controlling the accelerator pedal: from 40 to 160 km/h.
To activate the cruise control system, press the system ON/OFF switch to the ON position. The CRUISE indicator on the instrument panel will light up.
To set the driving speed:
1) Accelerate the car to the desired speed.
2) Press the COAST/SET switch and release it.
3) Release the accelerator pedal. The car will move at the specified speed.
To overtake another vehicle, press the accelerator pedal. Once you have completed overtaking, release the accelerator pedal. The vehicle will return to the preset speed. When driving the vehicle on steep inclines or descents, as well as on winding roads, the set speed may not be maintained. In such driving conditions, the cruise control system should be turned off.
You can cancel cruise control in one of three ways:
a. Click the CANCEL button.
b. Lightly press the brake pedal.
c. Turn off the cruise control using the main switch. The CRUISE indicator will go off.
If you press the brake pedal while the ACCEL/RES or COAST/SET button is pressed, the preset speed will be reset and the cruise control system will turn off.
The cruise control system will automatically turn off when the vehicle speed decreases (less than 13 km/h).
The selected speed mode will be canceled if you press the clutch pedal (models with a manual transmission) or move the range selector lever to another position (models with an automatic transmission or CVT).
To set a higher driving speed, use one of the three methods below:
a. Press the accelerator pedal. Once the vehicle has reached the desired speed, press and release the COAST/SET button.
b. Press and hold the ACCEL/RES button. After the car accelerates to the required speed, release the button.
c. Press and release the ACCEL/RES button repeatedly. Each time you press the button, the set speed will increase by approximately 1.6 km/h.
To reduce the set speed, you can use one of three methods:
a. Lightly press the brake pedal. Once the vehicle has slowed to the desired speed, press and release the COAST/SET button.
b. Press and hold the COAST/SET button. Once the vehicle has slowed down to the desired speed, release the button.
c. Press and release the COAST/SET button repeatedly. Each time you press the button, the set speed will decrease by approximately 1.6 km/h.
To restore the preset speed, press and release the ACCEL/RES button. If the current vehicle speed exceeds 40 km/h, the vehicle will restore to the last preset speed.
So, hello again everyone.
Another mini “tuning-pumping” of my saffron milk cap. I have long wanted to get the hang of installing remote control buttons for music and cruise control on the steering wheel. These devices were not included in my configuration. I’ll say right away that I don’t claim to be a pioneer, etc., I’m just describing my experience.
So, all those who want to get the hang of installing these buttons in their KIA SPORTAGE III of the European market on automatic, manual, petrol or diesel, need the following.
1) In order not to “physically” check the possibility of installing buttons on this set (of course, if you already have buttons, then you don’t need to read further =)))), go to the Mobis Free Access website: http://led- car.ru/mobis/login.php. Click Login to MOBIS
2) Switch to Russian mighty in the upper right corner. We enter your VIN (for dealer cars) - Slovak U5************, press ENTER, then in the window that opens in the upper right corner SEARCH (SEARCH).
3) In the window that opens, select the ELECTRIC group on the left, click on the picture “MULTIFUNCTION SWITCH”. We mark part 93490. Further options.
4) If your part is 934903R110 (lights up on the left in the column), then you are in luck. Let's move on to step 7.
5) If your part is 934902K200, then you need to go to step 6.
6) We order: 934903R110 – 1 piece steering column ring, 967003W050EQ – audio control button, 967003W350EQ – cruise control button, 561922K300 – the necessary cable from the steering wheel to the buttons themselves.
7) We order: 967003W050EQ – audio control button, 967003W350EQ – cruise control button, 561922K300 – the necessary cable from the steering column to the buttons themselves. The total price of the issue is 3-3.2 thousand rubles.
8) After the parts arrive, we will need: A 23 socket wrench (maybe a 22 would be suitable, but I only had a 23), a wrench for it, L-shaped star keys or a Euro key, which is usually included with furniture, a thin flat-head screwdriver, key 12, stationery knife (optional =))), marker.
9) Find a warm, cozy place or garage, if available.
10) Disconnect the negative terminal from the battery, having first placed the steering wheel in a vertical position, and do not remove the key from the lock.
11) At the back of the steering wheel we find large holes-recesses, insert the Euro key there, and unscrew the two sprockets. The screws will not fall out, they will remain inside. Turn the steering wheel to a horizontal position.
12) Remove the airbag with the KIA inscription by gently pulling it towards you. We see a cable from behind -> on the airbag we use a screwdriver or fingernails to hook the yellow clamping clip UP, it will rise a couple of millimeters. Then we disconnect the cable from the pillow itself. We move the cable to the side so as not to damage it. Don't be afraid, the airbag won't fire, and the SRS error won't light up if the contact opens.
13) Disconnect the second plug and the sound signal.
14) We assemble the key for 23 and the knob. Carefully mark the position of the steering wheel. I already had the factory marks, and I used them to guide me. Tighten the central nut, leaving it on the bolt for a couple of turns. We hit the steering wheel TO OURSELVES from the inside and it flies off the splines. Tighten the nut completely.
15) Turn the steering wheel over with the back side facing you, unscrew two more small screws from the recesses.
16) Unscrew the silver lower trim of the steering wheel spokes (two of the same screws).
17) We insert a flat-head screwdriver between the rear steering wheel casing and its body, gently press it out, and disconnect the silver lower trim from step 16 and the rear casing itself.
18) Turn the steering wheel over, unscrew two more screws securing the plugs in the places where we are going to install the buttons. We take out the plugs.
19) We carefully look at the place where the screws that we unscrewed first hang out. We see that they are hanging in the cartridges on the clamps. Use a screwdriver to press out the clamps and remove the cartridges along with the screws. This will make it easier for us. Next, we will collect.
20) Unpack our purchases. I did not replace the steering column ring, but it is easy to remove. We take out the train. We insert it from above UNDER the metal frame on which the airbag rests and route its wires left and right, not forgetting that the plug with the AUDIO sticker should be moved to the left side of the steering wheel (IN MY PHOTO IT IS NOT CORRECT, I was just imagining it.). We lay the Y-shaped plug so that it does not interfere with tightening the nut. The top connector must also go under the metal base.
21) We return the cartridges from step 19 to their place, they should be BELOW our wires routed to the buttons.
22) Insert connectors into the buttons, buttons into the steering wheel.
23) We tighten two screws into the lower holes from step 18 (exactly into the lower ones, do not confuse them).
24) We put the rear casing on the steering wheel, the silver trim and screw it on.
25) We screw two small screws into the buttons from the back, holding them, since there are no threads inside again.
26) Place the steering wheel exactly horizontally in the slots and seat it tightly. Tighten the central nut, not forgetting about the washer =)))
27) We connect the airbag, sound signal and our buttons to the block.
28) Install the airbag, tighten the two mounting screws at the back. For convenience, turn the steering wheel again to a vertical position or inclined, as is convenient for you.
29) Connect the battery, enjoy life and new options.
I spent 40 minutes on everything, most of which I thought about why nothing was working... it turns out I mixed up the plugs in a hurry =)))))))))))))
Have a nice trip everyone!
Cruise control buttons, audio for Kia Sportage 3 2010-2015 for installation in a regular place.
The buttons on the steering wheel of the Kia Sportage 3 are installed without problems.
When ordering, please indicate Type: Type A - Steering Wheel Without Heating / Type B - Steering Wheel With Heating.
1. Delivery methods
Pickup (m. Likhobory)
You can pick up the goods yourself by pre-ordering through the website in our store:
Moscow, st. MCC. Likhobory,
st. Likhoborskaya embankment, 14/4
Operating mode:
Mon-Thu – from 09:00 to 20:00
Fri – from 09:00 to 17:00
Sat – closed
Sun – closed
Courier delivery in Moscow is carried out to the actual address in the apartment or office.
- Delivery cost within the Moscow Ring Road - 400 rubles. (day to day or by agreement)
- Delivery cost outside the Moscow Ring Road - 400 + 30 rubles. per km (day to day or by agreement), a more accurate cost can be confirmed with the manager
CDEK (SDEK)
Courier delivery and pick-up of orders at pick-up points (pickup points) is carried out by the transport company SDEK. Fast and inexpensive delivery in more than 300 cities of Russia.
- To the point of delivery of orders (PVZ) in Moscow and Moscow Region (1-2 business days *
) - from 300 rub.
- To the point of delivery of orders (PVZ) to the regions of Russia (from 2 working days *
) - from 350 rub.
- By courier (SDEK) in Moscow and Moscow Region (1-2 working days *
) - from 350 rub.
- By courier (SDEK) in Russia (from 2 working days *
) - from 450 rub.
-
- The shelf life of the order at the pickup point is up to 14 days.
Boxberry
Boxberry delivery service to pick-up points (POIs) or by courier in hand. Branches are open in more than 450 cities of Russia.
Delivery is carried out only with 100% prepayment of the order on the website.
- To the point of delivery of orders (PVZ) in Moscow and Moscow Region (2 - 3 working days *
) - from 250 rub.
- To the point of delivery of orders (PVZ) to the regions of Russia (from 3 working days *
) - from 350 rub.
- By courier (Boxberry) in Moscow and Moscow Region (1 - 2 working days *
) - 350 rub.
- By courier (Boxberry) to Russian regions (from 2 working days *
) - from 400 rub.
-*The delivery schedule only takes into account working days. The day the order was sent is not taken into account.
- The shelf life of the order at the pickup point is up to 7 days.
Post office
The Federal State Unitary Enterprise "Russian Post" is the largest transport company, with branches in all cities and towns of Russia. Our website automatically calculates the shipping cost for your parcel.
- 1st class departure (from 2 to 14 days) - from 350 rubles. (for parcels weighing no more than 500 grams)
- Parcel (regular) - from 350 rubles. (for parcels weighing no more than 500 grams)
-*The delivery schedule only takes into account working days. The day the order was sent is not taken into account.
2. Payment methods
Cash (Moscow only)
Payment is made upon receipt of the goods at the store office (Moscow, Likhoborskaya embankment st. 14) or upon delivery of the goods by courier in Moscow
Bank card
Online payments from the site are made through the Yandex.Checkout payment service. Cards of payment systems Mir, Master Card, Visa and Maestro are accepted for payment. Payment is made without commission through a secure page by entering confirmation of the payment password from SMS. After payment, an electronic cash receipt is sent to your e-mail.
Payment for a placed order becomes possible after it is verified by the online store manager.
Account (for legal entities)
Issuing an invoice for payment without VAT. Without concluding a contract. The invoice is valid for 5 working days.
3. Payment through the Yandex.Checkout service (online payment)
You can pay for the ordered goods online by credit card immediately after creating the order and checking it with the online store manager. The payment link is contained in the letter that is sent to the e-mail you specified when placing your order.
- To pay by credit card, you will be redirected to the secure Yandex.Checkout payment page.
- When paying with a bank card, enter its number, expiration date, CVV code (indicated on the back of the card), as well as the owner’s first and last name.
- After filling in all the data, click on the “Pay” button.
4. Refund
Refunds to the Buyer depend on the payment method.
1. Cash payment (Moscow)
If payment in cash for the goods took place at the Moscow pick-up point (point of delivery of orders) or by courier delivery in Moscow, then cash return is possible only at the company’s office at Likhoborskaya embankment, 14, building 4. After agreement with the Buyer, the money is returned in cash or to a personal bank card. faces.
2. Cashless payments for individuals
To receive a full or partial refund to your card, you need to contact the store.
The money will automatically be returned to your card within 2-3 days. The exact refund period depends on how recently the order was placed and on the bank that issued the card (the maximum refund period cannot exceed 30 days). Payment information is processed on the Yandex.Checkout page, so any Buyer data (including bank card details) is not available to the online store. The transmission of information is protected using international technologies and protocols, which guarantees security for transactions with bank cards.
3. Cashless payments for legal entities
Refunds take up to 10 calendar days, and the period for crediting funds depends on the receiving bank.
Cash
Payment is made upon receipt of the goods at the store office or upon delivery of the goods by courier in Moscow
Transfer through banking services
Attention!!! After confirming the completed order, the manager sends by email the account details of Sberbank or Tinkoff Bank for payment in the online banking system or through other Banks.
C.O.D
Attention!!! Orders to the regions by Russian Post and CDEK are sent only with 100% payment. (cash on delivery to regions We DO NOT ship)
Cashless payment for legal entities
We work with Legal Entities (LEs), including by bank transfer. All documents necessary for accounting (original invoice for payment, invoice in form TORG-12) are issued along with the order upon receipt.
Online payment on the website
All users have access to online payment on the website using a bank card or through the Yandex Cashier service. Payment occurs on a secure page of the payment aggregator. After payment by email. An electronic cash receipt is received by mail.
Payment bank card on the website(no commission)Payment through the service Yandex Cashier(no commission)
Payment for a placed order is available only after the information is verified by the online store administrator.